June 28, 2022

Submersible Pump Cross Section Drawing. Part name 1 flange oval 2 lock nut 3 casing 4 parallel key 5 hex nut 6 oil seal 7 bush 8 thrust collar 9 rotor with shaft 10 stud 11. The grinder is made of chromium iron casting and is highly resistant to abrasion.

Patent US8491277 Submersible motor pump, motor pump, and
Patent US8491277 Submersible motor pump, motor pump, and from www.google.com

Aluminium) 37 cross section • ga drawing (model : 3 rubber cup nitrile rubber 4 lower flange stud s.s. As the pump works 24*7 in adverse environmental conditions, it has to be designed properly.

53' 107' 43' 4' 39'.

The pump should always be installed with the suction strainer above the slotted casing pipe. Tsurumi's unique oil lifter stabilizes the function of the mechanical seal and extends its sealing life. Pump hydraulic motor maintenance is not covered in this manual.

Curve, Pump Model Cross‐Section Drawing, And Parts List For Your Pump.

9 winding copper 10 end ring m.s. Part name 1 flange oval 2 lock nut 3 casing 4 parallel key 5 hex nut 6 oil seal 7 bush 8 thrust collar 9 rotor with shaft 10 stud 11. The pump is a hydraulic motor‐driven submersible model, capable of handling liquids that may be vol­

2 Base Plate Cover M.s.

Up to 50 °c maximum allowable amount of sand: Submersible pumps shall be furnished at the site complete with pump casings, shafts, bearings, seals, lubrication, piping assemblies, guide Description material 1 m5 screw for base cover s.s.

Pump Model Cross‐Section Drawing, And Parts List For Your Pump.

Slotted casing pipe (length up to rock level) 8. Aluminium) 37 cross section • ga drawing (model : 3 rubber cup nitrile rubber 4 check nut s.s.

They Are Further Classified As Gear Pumps, Piston Pumps, Lobe Pumps, Etc.

Requirements for furnishing and installing submersible sewage pumping units, together with base elbows, guide rail systems, variable frequency drives, liquid level controls, control panels, access covers and all appurtenances necessary for a complete installation. The following formula will calculate the required minimum sump capacity: Up to 306 m at 50 hz motor power:

Leave a Reply

Your email address will not be published.