May 26, 2022

How To Install Safety First Drawer Latches. Make sure this fits by entering your model number. Install the frame catch for interior door latches using a drill to make pilot holes for the screws.

Safety 1st SpringLoaded & Drawer Latch 10 Pack
Safety 1st SpringLoaded & Drawer Latch 10 Pack from

Carefully pry off the lock and then use a razor blade to remove the tape. Drill holes into the pencil marks. 4) use alcohol or hand sanitizer.

4) Use Alcohol Or Hand Sanitizer.

Drill a hole into the entrance of the cabinet using the striker as a guide. Recommended for children 0 to 6 years old. Drill a hole that matches the circumference of the shaft of the lock using an expanding drill bit or a keyhole saw.

You Put It On Both The Catch And The Latch To Hold Them In Place Before Screwing Them In.

Secure the lock over the ends of the slide, squeeze the lock to position it, and release to slide the lock into place. 5) use 3 m adhesive remover. Position the latch so that it lines up with the catch:

Easy, Wide Grip Surface Provides Quick Access For Parents.

Remove the positioning tape backing from the latch and adhere it to the marked position. Subsequently, question is, how do you baby. Check to make sure the alignment of the catch and the latch is correct and secure each piece with the provided screws.

Drill The Screws In Tightly Once The Latch Is In The Correct Place.

Decide whether you appetite the bolt on the top or basal bend of the door, again spiral it to the aperture anatomy about an inch from the corner. It 203 2010 instructions rock candy wireless ps3 controller manual Carefully pry off the lock and then use a razor blade to remove the tape.

Simple To Install And Easy To Use.

Screw the magnetic base to the shelf using a screwdriver. When you close your cabinet, and pull on it slightly, the door opens. Keep toddlers safe and preserve breakables while maintaining the unblemished look of your cabinets with the safety 1st complete magnetic locking system.

Leave a Reply

Your email address will not be published.